Modulu di cuntrollu di l'autonomia Carnegie Robotics 55001384
Specificazioni
- Produttore: Carnegie Robotica
- Numero di mudellu: 55001384
- Istruzzioni per l'integrazione: KDB 996369 D03 OEMManual v01
Descrizzione
Qualcomm® Robotics RB5 Core Kit consisting of Thundercomm TurboX C865 System on Module with customization around 12GB Ram and external antennas enabled for system integration. See Qualcomm or Thundercomm hardware manuals for specifications to each product.
Istruzzioni d'integrazione per i pruduttori di prudutti ospitanti secondu u Manuale OEM KDB 996369 D03 v01 (ricunnisciutu da ISED)
Lista di e regule FCC applicabili
- CFR 47 FCC PART 15 SUBPART C&E has been investigated. It is applicable to the modular. Specifically, an assessment of the worst case operating conditions has to be performed by the module integrator and tested on the host product for compliance to FCC part 15.247 and part 15.407.
Cundizioni specifiche d'usu operativa
- Stu modulu hè un modulu stand-alone. Se u pruduttu finale implicarà a cundizione di trasmissione multipla simultaneamente o diverse cundizioni operative per un trasmettitore modulare stand-alone in un host, u fabricatore di l'ospite hà da cunsultà cù u fabricatore di moduli per u metudu di stallazione in u sistema finale.
- Prucedure di moduli limitati. – Micca applicabile
- Disegni di antenne di traccia. – Micca applicabile
Considerazioni di esposizione RF
- To maintain compliance with FCC’s and ISED’s RF Exposure guidelines, this equipment should be installed and operated at a minimum distance of 20cm from your body.
Antenne
- This radio transmitter FCC ID: 2AMDR-55001384 / IC: 24410-55001384 has been approved by the Federal Communications Commission to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.
| Internu
Identificazione |
Descrizzione di l'antenna | Tippu d'antenna | Massimu guadagnu di l'antenna |
| Antenna 0** | Antenna Wi-Fi | Antenna Esterna 2X MIMO WIFI | 2.4G Wi-Fi: 1.2 dBi,
5G Wi-Fi: 2.0dBi |
| Antenna 1 | Antenna Wi-Fi | Antenna Esterna 2X MIMO WIFI | 2.4G Wi-Fi: 1.2 dBi,
5G Wi-Fi: 2.0dBi |
- Bluetooth has been disabled on device and has not been tested
Antennas Tested
- Abracon Part Number AECW0401W2-0600F_DS
- Taoglas MA210.K.CG.001
Etichetta è infurmazione di cunfurmità.
- The final end product must be labeled in a visible area with the following: Contains FCC ID: 2AMDR-55001384, IC: 24410-55001384
Informazioni nantu à i modi di prova è i requisiti di teste supplementari
- The Host manufacturers are strongly recommended to confirm compliance with FCC and ISED requirements for the transmitter when the module is installed in the host. Additional testing, Part 15 Subpart B and ICES-003 disclaimer The host manufacturer is responsible for compliance of the host system with module installed with all other applicable requirements for the system such as FCC Part 15 B and ICES-003.
Attenzione FCC
- Qualchese Cambiamenti o mudificazioni chì ùn sò micca appruvati espressamente da a parte rispunsevuli di u cumplimentu puderanu annullà l'autorità di l'utilizatore per operà l'equipaggiu.
FCC and ISED Statements
This device complies with Part 15 of the FCC Rules and with ICES-003 of the ISED rules. Operation is subject to the following two conditions:
- Stu dispusitivu ùn pò causari interferenza dannusu, è
- stu dispusitivu deve accettà ogni interferenza ricevuta, cumpresi interferenza chì pò causà operazione indesiderata.
NOTA IMPORTANTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and ICES-003 of the ISED Canada rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Riorientate o rilocate l'antenna di ricezione.
- Aumente a separazione trà l'equipaggiu è u ricevitore.
- Cunnette l'equipaggiu in una presa in un circuitu diversu da quellu à quale hè cunnessu u ricevitore.
- Cunsultate u rivenditore o un tecnicu espertu di radio/TV per aiutu.
Statements regarding human exposure
- With respect to radiofrequency radiation exposure Information, it is declared that this equipment complies with FCC and ISED radiation exposure limits set forth for an uncontrolled environment.
- This equipment should be installed and operated at a minimum distance of 20 cm between the radiator and your body.
- Stu trasmettitore ùn deve micca esse situatu o operatu in cunghjunzione cù qualsiasi altra antenna o trasmettitore.
FAQs
What are the recommended distances for RF exposure compliance?
The equipment should be installed and operated at a minimum distance of 20cm from the body to comply with FCC's and ISED's RF Exposure guidelines.
Can I use antennas not listed in the manual?
Antenna types not included in the approved list are strictly prohibited for use with this device to maintain compliance.
Documenti / Risorse
 |
Modulu di cuntrollu di l'autonomia Carnegie Robotics 55001384 [pdfManuale d'istruzzioni 55001384, 2AMDR-55001384, 2AMDR55001384, 55001384 Modulu di Cuntrollu di l'Autonomia, 55001384, Modulu di Cuntrollu di l'Autonomia, Modulu di Cuntrollu, Modulu |