Linear Access 3089 Multi Code Transmitter
Multi-code Transmitter Programming instructions
Metudu 1:
Receiver-based Programming
Passu 1:
- Locate the garage receiver and determine the unique 10-digit code. You can use the original 10-digit code or reset the new 10-digit code at this time. Take note of the unique code.
- TIP: Use a random sequence of numbers to make the code as secure as possible! Avoid easy-to-guess sequences.
Passu 2:
Remove the panel from the transmitter and expose the 10-digit code selector.
- Aduprate un cacciavite per sguassà u vitu.
- Pry open the lid.
Passu 3:
Using a small screwdriver, match the code to your receiver, which was determined in step 1. The switch has on and off positions, which are selected by pressing up or down. The 10-digit code on all remote controls must match what was selected in step 1.
Per esampLe:
| Ricevitore | Trasmettitore |
|---|---|
| ON: 2, 4, 6, 8, 10 | ON: 2, 4, 6, 8, 10 |
AVVISU: Please make sure to dial the switch to the top or bottom. If programming doesn’t succeed, please see troubleshooting on the next page.
Metudu 2:
Transmitter-to-Transmitter Programming
- Passu 1:
Aprite u casing di u vostru trasmettitore digià prugrammatu. - Passu 2:
You will see a row of small programmable numbered switches. They are in the ON or OFF position. - Passu 3:
Aprite u casing di u vostru novu trasmettitore. - Passu 4:
You will see a row of small programmable numbered switches. - Passu 5:
Set them in the same way as those set in your already-programmed transmitter. - Passu 6:
Your new transmitter control is programmed.
Instructions to Erase a Remote Control Transmitter
You may erase a transmitter by selecting a new unique code on your receiver. You can alter the 10-digit code on the transmitter so it DOES NOT match the receiver.
Risoluzione di prublemi
If you have any unresolved issues, please contact: SYhong2025@163.com.
- Soluzione 1: Please make sure to dial the switch to the top or bottom. If not, press it again.
- Soluzione 2: Check whether the 10-digit code of the transmitter and receiver are identical.
- Soluzione 3: Change another set of 10-digit code for the transmitter and receiver, then test again.
- Soluzione 4: Try to dial the Dip Switches to the opposite position. Then test again.
Sustituzione di batterie
Documenti / Risorse
 |
Linear Access 3089 Multi Code Transmitter [pdfManuale d'usu 3089 Multi Code Transmitter, 3089, Multi Code Transmitter, Code Transmitter, Transmitter |