Manuale di l'utente di l'unità M5STACK C6L Intelligent Edge Computing

Manuale di l'utente di l'unità M5STACK C6L Intelligent Edge Computing

Unit C6L is an intelligent edge computing unit integrated with the M5Stack_Lora_C6module — featuring an Espressif ESP32-C6 SoC and Semtech SX1262 LoRa transceiver — and engineered with a modular design for long-range, low-power LoRaWAN communication alongside high-speed 2.4 GHz Wi-Fi and BLE connectivity.
It includes a 0.66″ SPI OLED display for real-time data visualization, a WS2812Caddressable RGB LED for system-status indication, a built-in buzzer for audible alerts, and front-panel buttons (SYS_SW) with a reset switch for local interaction. Astandard Grove I²C interface allows seamless integration with M5Stack hosts and various Grove sensors. The onboard USB Type-C port supports ESP32- C6 firmware programming, serial debugging, and 5 V power input, while automatic power switching and multi-channel ESD/surge protection ensure stable operation. Unit C6L excels at real-time data acquisition, edge-intelligence processing, and remote control, making it ideal for IoT applications such as smart agriculture, environmental monitoring, industrial IoT, smart buildings, asset tracking, and urban infrastructure sensing.\

1.1. Unità C6L

1. Capacità di cumunicazione
   Integrated LoRa (Semtech SX1262), supporting LoRaWAN Class A/B/Candpointto-point modes 2.4 GHz Wi-Fi and BLE via ESP32-C6-MINI-1U
2. Processore è Prestazioni
   Main Controller: Espressif ESP32-C6 (single-core RISC-V, up to 40 MHz) On-chip Memory: 512 KB SRAM with integrated ROM
3. Gestione di l'energia è di l'energia
   Power Input: USB Type-C (5 V input) and Grove 5 V input
4. Display & Indicatori
   0.66″ SPI OLED display for real-time data visualization and status monitoringWS2812C addressable RGB LED for system-status indication Built-in buzzer for audible alerts
5. Interfaces & Controls
   Grove I²C interface (with 5 V power) for seamless connection to M5Stack hostsandGrove sensors USB Type-C port for firmware programming, serial debugging, and power input Front-panel buttons (SYS_SW) and reset switch (MCU_RST) for local control
6. Expansion & Debug Pads
   Bootloader pad: predefined jumper pad for entering bootloader mode Test points (TP1–TP8) for signal probing and in-circuit debug

2. SPECIFICATIONS

Parametru	Specificazione
MCU	Espressif ESP32-C6 (RISC-V monocore, finu à 40 MHz)
A cumunicazione	LoRaWAN; 2.4 GHz Wi-Fi BLE
Input di putenza	USB Type-C (5V) è Grove 5V
Corsu Voltage	3.3 V (LDO integratu)
Flash Storage	Memoria Flash SPI da 16 MB (128 Mbit)
Mostra	0.66”SPI OLED(128×64)
Indicatore	LED RGB indirizzabile WS2812C
Buzzer	Buzzer à bordu
Bottoni	System button (SYS_SW)and reset button(MCU_RST)
Interfacce	Grove I²C; USB Type-C; pad di bootloader; pad di debug TP1-TP8
Antenne	2×SSMB-JEF clamp cunnettori; 2 × cunnettori d'antenna IPEX-4
Temperature di funziunamentu	Temperature di funziunamentu
Funzioni supplementari	Multi-channel ESD/surge protection
U fabricatore	M5Stack Technology Co., Ltd Block A10, Expo Bay South Coast, Fuhai Street, Bao’an District, Shenzhen, China
Frequency Range for CE	2.4G Wi-Fi: 2412-2472MHz BLE: 2402-2480MHz Lora: 868-868.6MHz
EIRP massima per CE	BLE: 5.03dBm 2.4G Wi-Fi: 16.96dBm Lora: 9.45dBm
Category di ricevitore	The equipment provider declared that the receiver category for the EUTis2.

3. Avvisu FCC

Attenzione FCC:
Qualchese Cambiamenti o mudificazioni chì ùn sò micca appruvati espressamente da a parte rispunsevuli di u rispettu puderanu annullà l'autorità di l'utilizatore per operà l'equipaggiu. Stu dispusitivu hè conforme à a parte 15 di e regule FCC. U funziunamentu hè sottumessu à e duie cundizioni seguenti: (1) Stu dispusitivu ùn pò micca pruvucà interferenza dannosa, è (2) stu dispusitivu deve accettà ogni interferenza ricevuta, cumpresa l'interferenza chì pò causà operazione indesiderata.
NOTA IMPORTANTE:
Nota: This equipment has been tested and found to comply with the limits for a ClassBdigital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
curregge l'interferenza da una o più di e misure seguenti:

• Riorientate o rilocate l'antenna di ricezione.
• Increase the separation betweentheequipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. — Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator&your body.

I. Installing Arduino IDE(https://www.arduino.cc/en/Main/Software)
Cliccate per visità u ufficiale Arduino websitu, è selezziunate u pacchettu d'installazione per u vostru
operating system to download. Ⅱ. Installing Arduino Board Management
1. U Direttore di u Cunsigliu URL is used to index the development board information for specific platform. In the Arduino IDE menu, select File -> Preferenze

2.Copia a gestione di a scheda ESP URL sottu in u Manager Addizionale di u Cunsigliu
URLs: field, and save.
https://espressif.github.io/arduino-esp32/package_esp32_dev_index.json

3. In a barra laterale, selezziunate Board Manager, cercate ESP è cliccate nant'à Install.

4. In a barra laterale, selezziunate Board Manager, cercate M5Stack è cliccate nant'à Install.
Depending on the product used, select the corresponding development board under
Tools -> Board -> M5Stack -> {ESP32C6 DEV Module board}.

5. Cunnette u dispusitivu à u vostru urdinatore cù un cavu di dati per caricà u prugramma

Documenti / Risorse

Unità M5STACK C6L Unità di calculu di punta intelligente [pdfManuale di u pruprietariu M5UNITC6L, 2AN3WM5UNITC6L, Unità C6L Unità di Calculu Intelligente di Edge, Unità C6L, Unità di Calculu Intelligente di Edge, Unità di Calculu di Edge, Unità di Calculu, Unità

Referenze

• Manuale d'usu